Wire LED Dislay with 2 front/4 rear Backup Sensors System (SD6)
Item Price: $69.00 (Shipping & handling will be calculated based on the shipping zip code)
4 Rear and 2 Front ultrasonic sensors install in your bumper
Digital display unit shows the distance of object on the back when you reverse your car.
Distance unit is in inches
It shows the front distance of an object when your car is forwarding.
Warning Distance:118" - 11.8"
The system alerts with a variable multitone audio pulse and panel display
Specification
Display Type
Wire LED
Display Size
3.5" x 1" x 0.5"
Detecting Distance
118"-11.8"
Sensor's Style
Drill-in
Sensros Wire Length (Rear)
8 feet
Sensros Wire Length (Front)
20 feet
Power Supply
DC 12V
Step 1: Connect the Electric Power
Step 2: Install the Insert-Style Sensors
Open the trunk, on the back of the blanket, find the wires to the back light housing.
Use of a 12 volt multi-meter, Probe the appropriate wiring harness which
heads toward the reverse light connector of the vehicle, looking for the wire
which carries 12 volts + when reverse gear is engaged, and no voltage when
reverse gear is disengaged. Never use a test light to probe wires.
Once you have located the proper reverse light power wire, use a quick
connector to connect the RED wire from the control processer. You do
not need to cut any wire.
Drill four holes in the bumper via provided drilling bit.
Install four insert-style sensors.
Run the wires of sensors into the trunk, and plug in the control center.
Connect the power line of control center with the power line of backup light.